Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE (for Rear Disc Brake) › 2014.08–2016.08
RM25T0E _54 Brake _029918 BRAKE (REAR) _0138484 REAR BRAKE FLEXIBLE HOSE(for Rear Disc Brake) A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE(for Rear Disc Brake)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.

Attach a new clip to the flexible hose.


b.

Connect the flexible hose to the 3-way.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


c.
C312821C01
0.74,0.646 0.979,0.833 0.24,0.188 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)



NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.




Hide 47319F 2.INSTALL REAR FLEXIBLE HOSE LH

NOTICE:

When replacing both the left and right rear flexible hoses, as the left and right hoses each have a different shape, be sure to check the part number to confirm whether the hose is the left or right one before installing it.


a.

Connect the flexible hose with a new gasket and a new union bolt to the disc brake cylinder.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


b.

Set the flexible hose into place at the connecting point with the brake tube, and then install a new clip.


c.
C312820C01
2,2.104 2.219,2.375 0.219,0.271 10 true *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)



NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.




Hide 4.BLEED CLUTCH LINE