Home › Brake › BRAKE (REAR) › REAR BRAKE (for Rear Drum Brake)
RM25T0E _54 Brake _029918 BRAKE (REAR) _0138486 REAR BRAKE(for Rear Drum Brake) A

BRAKE (REAR)  REAR BRAKE(for Rear Drum Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.CHECK BRAKE SHOE LINING THICKNESS

a.
C111495

Remove the shoe inspection hole plug, and check the shoe lining thickness through the hole.

Minimum thickness:

1.0 mm (0.0394 in.)


If the thickness is less than the minimum, replace the shoe.


Hide 2.REMOVE REAR WHEEL

Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 42403 4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

a.

Remove the bolt from rear brake drum sub-assembly.


b.

Release the parking brake lever, and remove the drum and gasket.

HINT:

If the drum cannot be removed easily, perform the following procedures.



c.
C440438C01
1.5,1.896 1.5,1.375 true 1.521,1.01 0.917,0.75 0.917,0.75 0.781,0.75 true 1.292,3.698 1.417,4.083 1.417,4.083 1.5,4.083 true 0.885,3.542 0.531,3.125 0.531,3.125 0.427,3.125 true 1.542,4.01 1.792,4.219 0.25,0.208 10 true *1 0.604,0.688 0.917,0.885 0.313,0.198 10 false *2 0.25,3.042 0.563,3.24 0.313,0.198 10 false *2 1.417,1.927 1.667,2.135 0.25,0.208 10 true *1 0.083,2.49 0.396,2.688 0.313,0.198 10 false *B 0.063,0.073 0.375,0.271 0.313,0.198 10 false *A
*A w/o ABS
*B w/ ABS
*1 Automatic Adjust Lever
*2 Brake Shoe Adjuster


Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.


d.

Using another screwdriver, compress the shoe adjuster by turning the adjusting wheel.