Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81550B 1.REMOVE REAR COMBINATION LIGHT BULB (for Tail and Stop Light)
| *1 | Base Point |
| *2 | Unlock Position Mark |
|
Counterclockwise |
Turn the bulb socket counterclockwise until the base point is aligned with the unlock position mark to disconnect the bulb socket from the rear combination light lens LH.
|
Push |
|
Counterclockwise |
Push the rear combination light bulb in the direction indicated by the black arrow shown in the illustration, turn the bulb counterclockwise, and then remove the bulb from the bulb socket.
81550D 2.REMOVE REAR COMBINATION LIGHT BULB (for Backup Light)
| *1 | Base Point |
| *2 | Unlock Position Mark |
|
Counterclockwise |
Turn the bulb socket counterclockwise until the base point is aligned with the unlock position mark to disconnect the bulb socket from the rear combination light lens LH.
|
Push |
|
Counterclockwise |
Push the rear combination light bulb in the direction indicated by the black arrow shown in the illustration, turn the bulb counterclockwise, and then remove the bulb from the bulb socket.
81550D 3.REMOVE REAR COMBINATION LIGHT BULB (for Rear Turn Signal Light)
| *1 | Base Point |
| *2 | Unlock Position Mark |
|
Counterclockwise |
Turn the bulb socket counterclockwise until the base point is aligned with the unlock position mark to disconnect the bulb socket from the rear combination light lens LH.
|
Push |
|
Counterclockwise |
Push the side turn signal light bulb in the direction indicated by the black arrow shown in the illustration, turn the bulb counterclockwise, and then remove the bulb from the bulb socket.
81565 4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
Detach the wire harness clamp and remove the rear combination light socket and wire sub-assembly LH from the rear combination light lens LH.