Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM25T0E _59 Vehicle Exterior _029940 LIGHTING (EXT) _0138189 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

E112816C04
2.448,0.365 2.75,0.563 0.302,0.198 1.688,1 1.594,0.354 1.594,0.354 1.167,0.354 false 2.771,0.938 2.885,0.344 2.885,0.344 3.094,0.344 true 2.448,0.938 2.292,0.333 2.292,0.333 2.063,0.333 true 3.031,1.646 2.76,1.646 2.76,1.646 2.76,1.115 true 2.094,1.646 2.448,1.646 2.448,1.646 2.448,1.115 true 0.979,0.271 1.292,0.427 0.313,0.156 10 false *1 0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 3.177,0.25 3.333,0.448 0.156,0.198 10 false 1 1.938,0.26 2.094,0.458 0.156,0.198 10 false 2 3.104,1.552 3.26,1.75 0.156,0.198 10 false 3 1.969,1.542 2.125,1.74 0.156,0.198 10 false 4 2.521,0.385 2.979,0.583 0.458,0.198 10 false I19
*1 Shaft
*a Component without harness connected
(Stop Light Switch Assembly)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
I19-1 - I19-2 Shaft not pushed 10 kΩ or higher
Shaft pushed Below 1 Ω
I19-3 - I19-4* Shaft not pushed Below 1 Ω
Shaft pushed 10 kΩ or higher


*: for Brake Override System

If the result is not as specified, replace the stop light switch assembly.