Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85192 1.REMOVE WINDSHIELD WIPER ARM COVER
| *a | Protective Tape |
Using a screwdriver, detach the 3 claws and remove the windshield wiper arm cover.
Tape the screwdriver tip before use.
Use the same procedure for both windshield wiper arm covers.
2.REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
| *A | for Canvas Top |
| *B | except Canvas Top |
Remove the nut and the windshield wiper arm and blade assembly LH.
3.REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
| *A | for Canvas Top |
| *B | except Canvas Top |
Remove the nut and the windshield wiper arm and blade assembly RH.
55781F 4.REMOVE COWL TOP VENTILATOR LOUVER
Remove the 6 screws.
Detach the 5 claws and remove the cowl top ventilator louver.
55792E 5.REMOVE NO. 2 HEATER AIR DUCT HOLE COVER
55791E 6.REMOVE HEATER DUCT HOLE COVER
Detach the 4 claws and remove the heater duct hole cover.
85110 7.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
Disconnect the connector.
Remove the 4 bolts.
| *a | Protective Tape |
Using a screwdriver, remove the windshield wiper motor assembly from the link.
Tape the screwdriver tip before use.
85160 8.REMOVE WINDSHIELD WIPER LINK ASSEMBLY
Be careful not to damage the windshield when removing the windshield wiper link assembly.
| *a | Service Hole |
Remove the 6 bolts and windshield wiper link assembly through the service hole.