Home › Vehicle Exterior › WIPER / WASHER › RELAY
RM25T0E _59 Vehicle Exterior _029939 WIPER / WASHER _0138372 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85940 1.INSPECT OUT WIPER RELAY 1 (for Canvas Top)

a.
B383407

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage not applied to terminals 1 and 2 Below 1 Ω
3 - 5 10 kΩ or higher
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Below 1 Ω


If the result is not as specified, replace the relay.



Hide 85940D 2.INSPECT OUT WIPER RELAY 2 (for Canvas Top)

a.
B383406

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.



Hide 85948 3.INSPECT WINDSHIELD WIPER RELAY (for 24 V Battery)

a.
E193659

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage not applied to terminals 1 and 2 Below 1 Ω
3 - 5 10 kΩ or higher
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Below 1 Ω


If the result is not as specified, replace the relay.



Hide 85941 4.INSPECT WINDSHIELD WASHER RELAY (for 24 V Battery)

a.
E125026

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.