Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH(for 1HZ, 1VD-FTV)
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138398 VACUUM WARNING SWITCH(for 1HZ, 1VD-FTV) G

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for 1HZ, 1VD-FTV)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 2.INSPECT BRAKE BOOSTER ASSEMBLY (for 1GR-FE)

Hide 83390 3.INSPECT VACUUM WARNING SWITCH ASSEMBLY

a.

Start the engine and stop it after 1 or 2 minutes.


b.

Disconnect the connector from the vacuum warning switch assembly.


c.

Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher



d.

With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω



e.

Connect the connector to the vacuum warning switch assembly.