Use the same procedure for RHD and LHD vehicles.
The procedures listed below is for LHD vehicles.
73230 1.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
| *1 | Protruding Part |
| *a | Front |
| *b | 90° |
Pass the front seat inner belt assembly RH through the hole of the front seat cushion to the surface.
Connect the floor anchor of the front seat inner belt assembly RH to the floor anchor of the front seat lap outer belt sub-assembly.
Install the 2 seat belt floor anchors with the bolt.
Do not allow the anchor part of the seat belt to overlap the protruding part of the front seat inner belt assembly.
Make sure that the floor anchor is installed as shown in the illustration.