Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM › 2014.08–2017.09
RM25T0E _58 Vehicle Interior _029925 THEFT DETERRENT / KEYLESS ENTRY _0138323 IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM  B2793  Transponder Chip Malfunction  B2794  Unmatched Encryption Code  B2795  Unmatched Key Code  


DESCRIPTION

DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.

DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.

DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2793 Transponder Chip Malfunction A transponder chip malfunction (1 trip detection logic*). Key
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


B2794 Unmatched Encryption Code A key with an incomplete key code is inserted into the ignition key cylinder (1 trip detection logic*). Key
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


B2795 Unmatched Key Code A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). Key
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.



*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started. -

Related Data List and Active Test
DTC No. Data List and Active Test
B2793 Abnormal Status
B2794 Different Encrypt Code
B2795 Different Serial Number

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the key, refer to the Service Bulletin.

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



PROCEDURE

1.REREGISTER KEY
a.

Clear the DTC.

Body Electrical > Immobiliser > Clear DTCs
50002 260

b.

Reregister the key, and check that the engine starts with the key.

OK:

Engine starts.



Result:
Proceed to
OK
NG



OK

END (KEY CODE IS NOT REGISTERED NORMALLY)

NG

REPLACE KEY