Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
62512 1.REMOVE QUARTER INSIDE TRIM BOARD LH
Using a clip remover, remove the 3 clips.
Using a clip remover, detach the 2 clips and remove the quarter inside trim board LH.
73370 2.REMOVE REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH
Loosen the bolt and disconnect the floor anchor of the rear seat outer 3 point type belt assembly LH from the vehicle body.
Using a moulding remover D, detach the 2 claws and open the rear seat outer 3 point type belt shoulder anchor cover.
Loosen the bolt and disconnect the shoulder anchor of the rear seat outer 3 point type belt assembly LH from the vehicle body.
Remove the 2 bolts.
Detach the guide and remove the rear seat outer 3 point type belt assembly LH.