Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for Double Cab)
RM25T0E _58 Vehicle Interior _029931 SEAT BELT _0142770 REAR SEAT OUTER BELT ASSEMBLY(for Double Cab) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for Double Cab)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73370 1.INSTALL REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH

a.
B328714C01
1.177,0.542 1.427,0.708 0.25,0.167 10 true *1 1.25,1.75 1.5,1.917 0.25,0.167 10 true *2
*1 Bolt A
*2 Bolt B


Attach the guide and temporarily install the rear seat outer 3 point type belt assembly LH with the bolt (A) and (B).


b.

Tighten the bolt (A).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.

Tighten the bolt (B).

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

Connect the shoulder anchor of the rear seat outer 3 point type belt assembly LH with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


e.

Attach the 2 claws to close the rear seat outer 3 point type belt shoulder anchor cover.


f.

Connect the rear seat outer 3 point type belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


g.

Check that the rear seat outer 3 point type belt is not twisted.


Hide 62512 2.INSTALL QUARTER INSIDE TRIM BOARD LH

a.

Attach the 2 clips to install the quarter inside trim board LH.


b.

Install the 3 clips.