Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When replacing the front seat lap outer belt sub-assembly, replace the front seat lap inner belt sub-assembly together with it as a set.
73150 1.INSTALL FRONT CENTER SEAT LAP TYPE BELT ASSEMBLY
| *1 | Protruding Part |
| *a | Front |
| *b | 90° |
Pass the front seat lap outer belt sub-assembly through the hole of the front seat cushion to the surface.
Connect the floor anchor of the front seat lap outer belt sub-assembly to the floor anchor of the front seat inner belt assembly RH.
Install the 2 seat belt floor anchors with the bolt.
Do not allow the anchor part of the seat belt to overlap the protruding part of the front seat inner belt assembly.
Make sure that the floor anchor is installed as shown in the illustration.
| *a | Front |
| *b | 90° |
w/ Hook:
Install the hook.
Install the front seat inner belt assembly LH and front seat lap inner belt sub-assembly with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
w/ Seat Belt Warning System:
Connect the connector.