73380B 1.INSTALL NO. 4 SEAT LAP TYPE BELT ASSEMBLY
| *a | Front |
| *b | 90° |
Install the anchor part of the the No. 4 seat lap type belt assembly with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
Install the rear side seat assembly LH.
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Long Body)>INSTALLATION
| *1 | Band |
Pass the No. 4 lap type belt assembly through the band of the rear side seat assembly LH, and then install the No. 4 lap type belt assembly as shown in the illustration.
73330B 2.INSTALL NO. 1 SEAT LAP TYPE BELT ASSEMBLY
| *1 | Band |
Pass the No. 1 seat lap type belt assembly through the band of the rear side seat assembly LH, and then install the No. 1 seat lap type belt assembly as shown in the illustration.
| *a | Front |
| *b | 90° |
Install the seat belt floor anchor to the vehicle body with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
| *1 | Protruding Part |
| *a | Front |
| *b | 90° |
Connect the floor anchor of the No. 4 seat lap type belt assembly to the floor anchor of the No. 1 seat lap type belt assembly.
Install the 2 seat belt floor anchors with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
Do not allow the anchor part of the No. 4 seat lap type belt assembly to overlap the protruding part of the No. 1 seat lap type belt assembly.
73350B 3.INSTALL NO. 3 SEAT LAP TYPE BELT ASSEMBLY
| *1 | Band |
Pass the No. 3 seat lap type belt assembly through the band of the rear No. 2 side seat assembly LH, and then install the No. 3 seat lap type belt assembly as shown in the illustration.
| *a | Rear |
| *b | 45° |
Install the seat belt floor anchor to the vehicle body with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
73320B 4.INSTALL REAR SEAT NO. 2 LAP TYPE BELT ASSEMBLY
| *1 | Band |
Pass the rear seat No. 2 seat lap type belt assembl through the band of the rear No. 2 side seat assembly LH, and then install the rear seat No. 2 lap type belt assembly as shown in the illustration.
| *a | Front |
| *b | 90° |
Install the seat belt floor anchor to the vehicle body with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
| *1 | Protruding Part |
| *a | Front |
| *b | 90° |
Connect the floor anchor of the No. 2 seat lap type belt assembly to the floor anchor of the No. 3 seat lap type belt assembly.
Install the 2 seat belt floor anchors with the bolt.
Make sure that the floor anchor is installed as shown in the illustration.
Do not allow the anchor part of the No. 2 seat lap type belt assembly to overlap the protruding part of the No. 3 seat lap type belt assembly.