Home › Drivetrain › BF1B (TRANSFER / 4WD / AWD) › 4WD CONTROL SWITCH
RM25T0E _52 Drivetrain _030709 BF1B TRANSFER / 4WD / AWD _0142912 4WD CONTROL SWITCH G

BF1B TRANSFER / 4WD / AWD  4WD CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84722F 1.INSPECT TRANSMISSION CONTROL SWITCH

a.
C311916C01
0.083,0.104 0.396,0.302 0.313,0.198 10 false *a
*a Component without harness connected
(Transmission Control Switch)


Measure the resistance according to the value (s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 - 4 Transmission control switch is pushed Below 1 Ω
Transmission control switch is not pushed 10 kΩ or higher


If the result is not as specified, replace the transmission control switch.


b.
C311917C01
1.865,3.26 2.031,3.26 2.031,3.26 2.031,2.76 true 2.417,3.25 2.25,3.25 2.25,3.25 2.25,2.75 true 1.917,0.083 1.75,0.083 1.75,0.083 1.75,0.667 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 1.99,0.01 2.302,0.208 0.313,0.198 10 false *b 2.479,3.167 3.25,3.365 0.771,0.198 10 false ILL + 1.5,3.167 2.271,3.365 0.771,0.198 10 false ILL -
*a Component without harness connected
(Transmission Control Switch)
*b Transmission Control Switch Illumination


Apply battery voltage between the terminals of the transmission control switch, and check the illumination condition of the transmission control switch.

Standard Resistance:
Measurement Condition Switch Condition
Battery positive (+) → 1 (ILL+)
Battery negative (-) → 2 (ILL-)
Illuminates


If the result is not as specified, replace the transmission control switch.