Home › Drivetrain › R151F (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM25T0E _52 Drivetrain _029903 R151F MANUAL TRANSMISSION / TRANSAXLE _0137555 INPUT SHAFT G

R151F MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33368 1.INSPECT NO. 2 SYNCHRONIZER RING

a.
C314955

Apply gear oil to the cone of the input shaft, and check that it does not turn in either direction while pushing the No. 2 synchronizer ring.

If it can turn, replace the No. 2 synchronizer ring.


b.
C315193

Push the No. 2 synchronizer ring against the cone of the input shaft. Measure the clearance between the No. 2 synchronizer ring and input shaft.

Standard clearance:

0.70 to 1.70 mm (0.0276 to 0.0669 in.)


If the clearance is not as specified, replace the No. 2 synchronizer ring with a new one.