Home › Drivetrain › BF1B (TRANSFER / 4WD / AWD) › TRANSFER ASSEMBLY
RM25T0E _52 Drivetrain _030709 BF1B TRANSFER / 4WD / AWD _0142856 TRANSFER ASSEMBLY G

BF1B TRANSFER / 4WD / AWD  TRANSFER ASSEMBLY  INSPECTION  


PROCEDURE

Hide 36203 1.INSPECT TRANSFER HIGH SPEED OUTPUT GEAR THRUST CLEARANCE

a.
C271247

Using a feeler gauge, measure the thrust clearance of the transfer high speed output gear sub-assembly.

Standard clearance:

0.10 to 0.25 mm (0.0039 to 0.0098 in.)


Maximum clearance:

0.25 mm (0.0098 in.)


If the clearance is more than the maximum, replace the transfer high speed output gear sub-assembly.


Hide 36204 2.INSPECT TRANSFER LOW SPEED OUTPUT GEAR THRUST CLEARANCE

a.
C271248

Using a feeler gauge, measure the thrust clearance of the transfer low speed output gear sub-assembly.

Standard clearance:

0.10 to 0.25 mm (0.0039 to 0.0098 in.)


Maximum clearance:

0.25 mm (0.0098 in.)


If the clearance is more than the maximum, replace the transfer low speed output gear sub-assembly.


Hide 36203 3.INSPECT TRANSFER HIGH SPEED OUTPUT GEAR RADIAL CLEARANCE

C271250

a.

Using a dial indicator, measure the radial clearance of the transfer high speed output gear sub-assembly.

Standard clearance:

0.019 to 0.068 mm (0.0007 to 0.0027 in.)


Maximum clearance:

0.068 mm (0.0027 in.)


If the clearance is more than the maximum, replace the transfer high speed output gear sub-assembly, rear transfer output shaft or transfer output shaft taper roller bearing.


Hide 36204 4.INSPECT TRANSFER LOW SPEED OUTPUT GEAR RADIAL CLEARANCE

a.
C271249

Using a dial indicator, measure the radial clearance of the transfer low speed output gear sub-assembly.

Standard clearance:

0.019 to 0.068 mm (0.0007 to 0.0027 in.)


Maximum clearance:

0.068 mm (0.0027 in.)


If the clearance is more than the maximum, replace the transfer low speed output gear sub-assembly, rear transfer output shaft or transfer output shaft taper roller bearing.