RM25T0E _V1 General _029810 SPECIFICATIONS _0145748 1VD-FTV ENGINE CONTROL F
SPECIFICATIONS 1VD-FTV ENGINE CONTROL SERVICE DATA
DIESEL THROTTLE BODY
| Tester Connection |
Condition |
Specified Condition |
| 1 (DUTY) - Body ground |
Always |
10 kΩ or higher |
| 2 (+B) - Body ground |
Always |
10 kΩ or higher |
| 3 (GND) - Body ground |
Always |
10 kΩ or higher |
| 2 (+B) - 1 (DUTY) |
Always |
10 kΩ or higher |
| 1 (DUTY) - 3 (GND) |
Always |
10 kΩ or higher |
ACCELERATOR PEDAL
| Tester display |
Condition |
Specified Condition |
| Accelerator position No. 1 |
Released |
10 to 22% |
| Depressed |
52 to 90% |
| Accelerator position No. 2 |
Released |
24 to 40% |
| Depressed |
68 to 99% |
MASS AIR FLOW METER
| Tester Connection |
Condition |
Specified Condition |
| 4 (THA) - 5 (E2) |
Always |
0.48 to 17.7 kΩ |
CAMSHAFT POSITION SENSOR
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
Cold |
835 to 1400 Ω |
| 1 - 2 |
Hot |
1060 to 1645 Ω |
CRANKSHAFT POSITION SENSOR
| Tester Connection |
Condition |
Specified Condition |
| 1 (NE+) - 2 (NE-) |
Cold |
1630 to 2740 Ω |
| 1 (NE+) - 2 (NE-) |
Hot |
2065 to 3225 Ω |
ENGINE COOLANT TEMPERATURE SENSOR
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
approximately 20°C (68°F) |
2.29 to 2.60 kΩ |
| 1 - 2 |
approximately 80°C (176°F) |
0.302 to 0.327 kΩ |
INTAKE AIR TEMPERATURE SENSOR
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
approximately 20°C (68°F) |
2.21 to 2.65 kΩ |
| 1 - 2 |
approximately 60°C (140°F) |
0.55 to 0.61 kΩ |
MANIFOLD ABSOLUTE PRESSURE SENSOR
| Tester Connection |
Condition |
Specified Condition |
| T25-3 (VC) - T25-1 (E2) |
Ignition switch ON |
4.75 to 5.25 V |
POWER STEERING OIL PRESSURE SWITCH
| Condition |
Specified Condition |
| Power steering operation |
ON |
| Power steering not operation |
OFF |
RELAY (EFI MAIN RELAY)
| Tester Connection |
Condition |
Specified Condition |
| 3 - 5 |
battery voltage is not applied between 1 and 2 |
10 kΩ or higher |
| 3 - 5 |
battery voltage is applied between 1 and 2 |
Below 1 Ω |
RELAY (EDU1, EDU2)
| Tester Connection |
Condition |
Specified Condition |
| 3 - 5 |
battery voltage is not applied between 1 and 2 |
10 kΩ or higher |
| 3 - 5 |
battery voltage is applied between 1 and 2 |
Below 1 Ω |