RM25T0E _V1 General _029810 SPECIFICATIONS _0145749 1GR-FE FUEL F
SPECIFICATIONS 1GR-FE FUEL SERVICE DATA
FUEL SYSTEM
| Fuel pressure |
Standard fuel pressure |
281 to 287 kPa (2.9 to 2.9 kgf/cm2, 41 to 42 psi) |
| Remains for 5 minutes after engine has stopped |
147 kPa (1.5 kgf/cm2, 21 psi) or higher |
FUEL INJECTOR
| Fuel injector assembly |
Standard resistance |
11.6 to 12.4 Ω at 20°C (68°F) |
| Standard injection volume |
76 to 91 cc (4.6 to 5.6 cu. in.) per 15 seconds |
| Difference between each fuel injector |
15 cc (0.9 cu. in.) or less |
| Standard fuel drop |
1 drop or less per 17 minutes |
FUEL PUMP
| Fuel pump |
Standard resistance |
0.2 to 3.0 Ω at 20°C (68°F) |
FUEL PUMP
| Fuel pump resistor |
Standard resistance |
0.71 to 0.75 Ω at 20°C (68°F) |
FUEL TANK SELECT VALVE (for Fuel Sub Tank)
| Tester Connection |
Condition |
Specified Condition |
| 1 - Body ground |
Always |
1 MΩ or higher |
| 2 - Body ground |
| 1 - 2 |
20°C (68°F) |
12 to 15 Ω |
FUEL TANK SELECT SWITCH (for Fuel Sub Tank)
| Tester Connection |
Condition |
Specified Condition |
| 3 - 4 |
Switch OFF |
1 MΩ or higher |
| Switch ON |
Below 1 Ω |
FUEL SENDER GAUGE ASSEMBLY (for Double Tank Type)
| Tester Connection |
Condition |
Specified Condition |
| 2 - 3 |
F (Upper End) |
12 to 18 Ω |
| E (Lower End) |
405 to 415 Ω |
FUEL SENDER GAUGE ASSEMBLY (for 90 L Tank Carried in Middle)
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
F (Upper End) |
12 to 18 Ω |
| E (Lower End) |
405 to 415 Ω |
FUEL SENDER GAUGE ASSEMBLY (for 90 L Tank Carried in Rear)
| Tester Connection |
Condition |
Specified Condition |
| 2 - 3 |
F (Upper End) |
12 to 18 Ω |
| E (Lower End) |
405 to 415 Ω |
FUEL SENDER GAUGE ASSEMBLY (for 130 L Tank)
| Tester Connection |
Condition |
Specified Condition |
| 1 - 3 |
F (Upper End) |
12 to 18 Ω |
| E (Lower End) |
405 to 415 Ω |