Use the same procedure for RHD and LHD vehicles.
The procedures listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73298B 1.REMOVE QUARTER TRIM BELT HOLE COVER LH
Remove the 2 screws and quarter trim belt hole cover LH.
73299 2.REMOVE NO. 2 QUARTER TRIM BELT HOLE COVER LH
Remove the 2 screws and No. 2 quarter trim belt hole cover LH.
62512 3.REMOVE QUARTER INSIDE TRIM BOARD LH
Detach the 13 clips and remove the quarter inside trim board LH.
73370 4.REMOVE REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH
Loosen the bolt and disconnect the floor anchor of the rear seat outer 3 point type belt assembly LH from the vehicle body.
Using a moulding remover D, detach the 2 claws and open the rear seat outer 3 point type belt shoulder anchor cover.
Loosen the bolt and disconnect the shoulder anchor of the rear seat outer 3 point type belt from the vehicle body.
Remove the bolt.
Detach the 3 guides and remove the rear seat outer 3 point type belt assembly LH.