Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for Short Body) › 2014.08–2017.01
RM25T0E _58 Vehicle Interior _029931 SEAT BELT _0142834 REAR SEAT OUTER BELT ASSEMBLY(for Short Body) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for Short Body)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73370 1.INSTALL REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH

a.
B388239

Attach the 3 guides and temporarily install the rear seat outer 3 point type belt assembly LH with the bolt.


b.

Tighten the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


c.

Connect the shoulder anchor of the rear seat outer 3 point type belt assemblyLH with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

Attach the 2 claws to close the rear seat outer 3 point type belt shoulder anchor cover.


e.

Connect the rear seat outer 3 point type belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


f.

Check that the rear seat outer 3 point type belt is not twisted.


Hide 62512 2.INSTALL QUARTER INSIDE TRIM BOARD LH

a.

Install the quarter inside trim board LH with the 13 clips.


Hide 73298B 3.INSTALL QUARTER TRIM BELT HOLE COVER LH

a.

Install the quarter trim belt hole cover LH with the 2 screws .


Hide 73299 4.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER LH

a.

Install the No. 2 quarter trim belt hole cover LH with the 2 screws.