| Battery | Standard specific gravity | 1.25 to 1.29 at 20°C (68°F) | ||
| Standard voltage | 12.6 to 12.8 V at 20°C (68°F) | |||
| Charging circuit without load | Standard current | 10 A or higher | ||
| Standard voltage | for 12 V Type | 13.8 to 14.7 V at 25°C (77°F) (when engine speed at 2000rpm) |
||
| 13.2 to 14.0 V at 135°C (275°F) (when engine speed at 2000rpm) |
||||
| for 24 V Type | 27.7 to 28.7 V at 25°C (77°F) (when engine speed at 2000rpm) |
|||
| 26.0 to 28.7 V at 135°C (275°F) (when engine speed at 2000rpm) |
||||
| Charging circuit with load | Standard current | for 12 V type | 30 A or higher | |
| for 24 V type | 15 A or higher | |||
| Generator brush holder assembly | Standard brush length | 9.5 to 11.5 mm (0.374 to 0.453 in.) | ||
| Minimum brush length | 4.5 mm (0.177 in.) | |||
| Generator regulator assembly | Standard resistance | Terminal F - Terminal B | Below 1 Ω or higher than 10 kΩ | |
| Terminal F - Terminal E | Below 1 Ω or higher than 10 kΩ | |||
| Generator rotor assembly | Standard resistance | Slip ring - Slip ring | for 30 A Type | 11.6 to 12.4 Ω at 20°C (68°F) |
| for 80 A Type | 2.1 to 2.5 Ω at 20°C (68°F) | |||
| Slip ring - Rotor core | 10 MΩ or higher | |||
| Standard diameter | 14.2 to 14.8 mm (0.559 to 0.583in.) | |||
| Minimum diameter | 14.0 mm (0.551 in.) | |||
| Generator drive end frame | Standard resistance | Coil lead - Coil lead | Below 1 Ω | |
| Standard resistance | Coil lead - Generator drive end frame | 10 kΩ or higher | ||