1.DRAIN MANUAL TRANSMISSION OIL
Stop the vehicle on a level surface.
Remove the manual transmission case plug and gasket.
Remove the drain plug sub-assembly and gasket to drain the manual transmission oil.
Install a new gasket and the drain plug sub-assembly.
2.ADD MANUAL TRANSMISSION OIL
| *a | 0 to 5 mm (0 to 0.196 in.) |
Add manual transmission oil until the oil level is within 0 to 5 mm (0 to 0.196 in.) from the bottom of the manual transmission case plug opening.
| Oil grade | Oil viscosity | Standard capacity |
|---|---|---|
| GL-3 (GL-4) | SAE 75W-90 | 2.9 liters (3.1 US qts, 2.6 Imp. qts) |
| *1 | 22 x 24 mm Long Offset Wrench |
| *a | Torque Wrench Fulcrum Length |
Using a SST and 22 x 24 mm long offset wrench, install a new gasket and the manual transmission case plug.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a long offset wrench (fulcrum length of 300 mm (11.811 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 14 N*m (143 kgf*cm, 10 ft.*lbf)