Home › Drivetrain › H152F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION OIL › from 2016.08
RM25T0E _52 Drivetrain _058021 H152F MANUAL TRANSMISSION / TRANSAXLE _0282324 MANUAL TRANSMISSION OIL G

H152F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK TRANSMISSION OIL

a.

Stop the vehicle on a level surface.


b.
C312346

Remove the manual transmission case plug and gasket.


c.
D025304C25
0.708,1.344 1,1.573 0.292,0.229 10 false *a
*a 0 to 5 mm (0 to 0.196 in.)


Check that the oil level is within 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the manual transmission case plug opening.

If the result is not as specified, add transmission oil.

Manual Transmission Oil:
Oil grade Oil viscosity Standard capacity
GL-3 (GL-4) SAE 75W-90 2.9 liters (3.1 US qts, 2.6 Imp. qts)


NOTICE:
·

Too much or too little oil will lead to transmission problems.

·

After adjusting the oil level, drive the vehicle and check the oil level again.




d.

Check for oil leakage when the oil level is low.

If leakage is found, repair the area necessary to stop the leak. Replace damaged parts as necessary.


e.
C357031C02
1.5,0.979 1.885,0.979 true 0.948,1.531 1.104,1.531 1.104,1.531 1.542,2.104 true 0.625,1.448 0.948,1.656 0.323,0.208 10 false SST 1.927,0.896 2.208,1.156 0.281,0.26 10 true *1 2.208,2.969 2.5,3.427 0.292,0.458 10 true *a
*1 22 x 24 mm Long Offset Wrench
*a Torque Wrench Fulcrum Length


Using a SST and 22 x 24 mm long offset wrench, install a new gasket and the manual transmission case plug.

SST
09820-30020  

Torque:
Specified tightening torque : 37.24 N*m (380 kgf*cm, 27 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a long offset wrench (fulcrum length of 300 mm (11.811 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 14 N*m (143 kgf*cm, 10 ft.*lbf)