Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2016.08
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0282525 ECD SYSTEM(w/ DPF) D

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  FREEZE FRAME DATA  


DESCRIPTION


A301856E12
2.24,0.938 3.083,1.167 0.844,0.229 10 false 0.5 seconds 0.344,0.938 1.188,1.167 0.844,0.229 10 false 0.5 seconds 1.323,0.927 2.167,1.156 0.844,0.229 10 false 0.5 seconds 0.406,2.813 2.844,3.083 2.438,0.271 10 false Freeze frame data recorded 2.375,0.302 3.26,0.563 0.885,0.26 10 false DTC is stored

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the air fuel ratio was lean or rich, as well as the other data recorded at the time of a malfunction.

HINT:

If it is impossible to duplicate the problem even though a DTC is stored, confirm the freeze frame data.


The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

-

3 data sets from before the DTC was stored

-

1 data set from when the DTC was stored

-

1 data set from after the DTC was stored

These data sets can be used to simulate the condition of the vehicle from around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.




PENDING FREEZE FRAME DATA


HINT:

Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Engine and ECT / Trouble Codes.


e.

Select a DTC in order to display its pending freeze frame data.

HINT:
·

Pending freeze frame data is cleared when any of the following occurs.

-

Using the GTS, the DTCs are cleared.

-

The cable is disconnected from the negative (-) auxiliary battery terminal.

-

40 trips with the engine fully warmed up have been performed after returning to normal.

(Pending freeze frame data will not be cleared by only returning the system to normal.)


·

With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new one of the newly detected DTC in the next trip.



A251781E08
0.156,0.104 6.771,0.635 6.615,0.531 10 When a DTC is detected in both the first and second trips but the system returns to normal from the third trip (2 trip logic DTC): 0.146,1.625 1.24,1.802 1.094,0.177 10 Ignition Switch 1.302,1.458 2.115,1.75 0.813,0.292 10 ON 1.302,1.844 1.552,2.021 0.25,0.177 10 Off 0.156,2.583 1.198,2.896 1.042,0.313 10 Pending Freeze Frame Data 1.333,2.5 1.781,2.698 0.448,0.198 10 Stored 1.323,2.781 1.771,3.125 0.448,0.344 10 Not Stored 0.125,3.708 1.042,4.406 0.917,0.698 10 Freeze Frame Data 1.292,3.667 1.74,3.865 0.448,0.198 10 Stored 0.365,4.698 1.75,4.906 1.385,0.208 10 :Malfunction detected 0.365,5 2.083,5.208 1.719,0.208 10 :Malfunction not detected 2.073,0.885 2.76,1.094 0.688,0.208 10 (First Trip) 2.823,0.885 3.781,1.125 0.958,0.24 10 (Second Trip) 3.781,0.885 4.74,1.125 0.958,0.24 10 (Third Trip) 4.594,0.896 5.552,1.135 0.958,0.24 10 (Fourth Trip) 1.302,3.938 1.74,4.292 0.438,0.354 10 Not Stored

A251782E11
0.188,0.177 7.063,0.594 6.875,0.417 10 When 2 trip DTC is first detected in the first trip and another 2 trip DTC is first detected in the second trip: 0.479,1.531 1.396,1.844 0.917,0.313 10 Ignition Switch 1.781,1.365 2.302,1.583 0.521,0.219 10 ON 1.781,1.719 2.125,1.896 0.344,0.177 10 Off 0.479,2.323 1.542,2.688 1.063,0.365 10 Pending Freeze Frame Data A 0.479,3.271 1.479,3.667 1,0.396 10 Pending Freeze Frame Data B 1.781,2.25 2.24,2.417 0.458,0.167 10 Stored 1.781,3.156 2.24,3.323 0.458,0.167 10 Stored 1.781,2.531 2.208,2.948 0.427,0.417 10 Not Stored 1.781,3.448 2.208,3.865 0.427,0.417 10 Not Stored 0.677,4.146 3.188,4.385 2.51,0.24 10 :Pending malfunction A detected 0.677,4.625 3.188,4.865 2.51,0.24 10 :Pending malfunction B detected 0.677,5.135 2.771,5.365 2.094,0.229 10 :No malfunction detected 4.198,2.875 5.302,3.052 1.104,0.177 10 Uploaded 2.635,0.719 3.333,1.031 0.698,0.313 10 (First Trip) 3.542,0.719 4.677,0.99 1.135,0.271 10 (Second Trip) 4.604,0.719 5.729,1.052 1.125,0.333 10 (Third Trip) 5.521,0.719 6.719,1.052 1.198,0.333 10 (Fourth Trip)



LIST OF FREEZE FRAME DATA



Powertrain > Engine and ECT
Tester Display
Vehicle Speed
Target Idle Engine Speed
Engine Speed
Calculate Load
MAF
Atmosphere Pressure
MAP
Coolant Temp
Intake Air
Intake Air Temp (Turbo) Supported
Intake Air Temp (Turbo)
Engine Run Time
Initial Engine Coolant Temp
Initial Intake Air Temp
Battery Voltage
Alternate Duty Ratio
Glow Relay Request
Glow Relay Request #2
Glow Indicator Supported
Glow Indicator
Accel Position
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
Target Throttle Position Supported
Target Throttle Position
Target Throttle Position #2 Supported
Target Throttle Position #2
Actual Throttle Position Supported
Actual Throttle Position
Actual Throttle Position #2 Supported
Actual Throttle Position #2
Throttle Motor DUTY
Throttle Motor DUTY #2
Throttle Close Learning Val.
Throttle Close Learning Val.#2
Throttle Sensor Volt %
Throttl Sensor #2 Volt %
Injection Volume
Inj. FB Vol. for Idle
Inj Vol Feedback Learning
Idle Signal Output Value
Idle Signal Output Value #2
Injection Feedback Val #1
Injection Feedback Val #2
Injection Feedback Val #3
Injection Feedback Val #4
Injection Feedback Val #5
Injection Feedback Val #6
Injection Feedback Val #7
Injection Feedback Val #8
Pilot 1 Injection Period
Pilot 2 Injection Period
Main Injection Period
After Injection Period
Pilot 1 Injection Timing
Pilot 2 Injection Timing
Main Injection Timing
After Injection Timing
Pilot Quantity Learning
Injector Pilot Quantity Learning
Actuator Pilot Quantity Learning
Temperature Pilot Quantity Learning
Catalyst Pilot Quantity Learning
Injection Pressure Correction
Injection EDU Relay Request
Injection EDU Relay Request #2
Target Common Rail Pressure Supported
Target Common Rail Pressure
Common Rail Pressure Supported
Common Rail Pressure
Fuel Temperature Supported
Fuel Temperature
Target Pump SCV Current
Pump SCV Learning Value
Pump SCV Status
Pump SCV Duty Request
Pressure Discharge Valve
AF Lambda B1S1
AFS Voltage B1S1
AFS Current B1S1
A/F Heater Duty B1S1
AF Sensor Learning Value
Target EGR Valve Pos Supported
Target EGR Valve Pos
Target EGR Valve Pos #2 Supported
Target EGR Valve Pos #2
Actual EGR Valve Pos Supported
Actual EGR Valve Pos
Actual EGR Valve Pos #2 Supported
Actual EGR Valve Pos #2
EGR Position Sensor
EGR Motor Duty #1
EGR Close Lrn. Val.
EGR Cooler Bypass VSV
EGR Cooler Bypass Position
Target Booster Pressure Supported
Target Booster Pressure
Target VN Turbo Position Supported
Target VN Turbo Position
Target VN Turbo Position #2 Supported
Target VN Turbo Position #2
Actual VN Position Supported
Actual VN Turbo Position
Actual VN Position #2 Supported
Actual VN Turbo Position #2
VN Motor Duty
VN Turbo Max Angle
VN Turbo Min Angle
Exhaust Temperature B1S1 Supported
Exhaust Temperature B1S1
Exhaust Temperature B1S2 Supported
Exhaust Temperature B1S2
Exhaust Temperature B1S3 Supported
Exhaust Temperature B1S3
DPF Differential Pressure Supported
DPF Differential Pressure
Catalyst Differential Press
Diff. Press. Sensor Corr.
Exhaust Fuel Addition Injector Status
Exhaust Fuel Addition FB
DPNR/DPF Status Reju(PM)
PM Accumulation Ratio
Starter Signal
Power Steering Signal
Low Gear Switch
Clutch Switch
Transfer L4
Stop Light Switch
A/C Signal
Idle Up SW
Immobiliser Communication
Clogged Fuel Filter Switch
TC Terminal
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
Dist Batt Cable Disconnect
IG OFF Elapsed Time
TC and TE1
Engine Speed (Starter Off)
Starter Count
Run Dist of Previous Trip
Glow Request Lighting Time
IG-ON Time
MAF Low
Boost Pressure Low
Common Rail Pressure Low
Engine Coolant Temp High
MAF/Estimate MAF Ratio
Rough Idle #1
Rough Idle #2
Rough Idle #3
Rough Idle #4
Rough Idle #5
Rough Idle #6
Rough Idle #7
Rough Idle #8
Electric Duty Feedback Value
A/C Duty Feedback Value
PS Duty Feedback Value
Idle Injection Volume (Min)
Engine Starting Time
Minimum Engine Speed
ACT VSV
Brake Override System
Immobiliser Fuel Cut History
Cruise Main SW
Shift SW Status (N,P Range) Supported
Shift SW Status (N,P Range)