Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2016.08
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0282525 ECD SYSTEM(w/ DPF) C

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  P0630  VIN not Programmed or Mismatch - ECM / PCM  


DESCRIPTION

DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0630 VIN not Programmed or Mismatch - ECM / PCM VIN not stored in ECM
Input VIN in ECM not accurate (1 Trip detection logic).
ECM Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Read the DTCs.

Result:
Result Proceed to
DTC P0630 is output A
DTC P0630 and other DTCs are output B


NOTICE:

If P0630 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P0630 are set, check them first.


HINT:

If any DTCs other than P0630 are output, troubleshoot those DTCs first.




A

2.INPUT VIN OR FRAME NUMBER

B

2.INPUT VIN OR FRAME NUMBER

Result:
Proceed to
NEXT



NEXT

END