Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/ VSC) › 2016.08–2017.01
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0282726 BRAKE MASTER CYLINDER(w/ VSC) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 47201 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.
C364629

Install a new O-ring to the brake master cylinder sub-assembly.


b.

Install a new brake master cylinder gasket to the brake master cylinder sub-assembly.


c.

Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



d.
C364630C01
1.052,2.708 1.365,2.906 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.

Torque:
Specified tightening torque : 19.5 N*m (199 kgf*cm, 14 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.378 in.)): 17.4 N*m (177 kgf*cm, 13 ft.*lbf)




e.

Connect the brake fluid level warning switch connector to the brake master cylinder sub-assembly.


Hide 4.BLEED CLUTCH LINE (for RHD)