Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.
Set SST on the master cylinder and lower the rod of SST until it touches the piston.
SST: 09737-00012 can also be used.
Apply chalk to the flat tip of SST rod. Turn SST upside down and measure the clearance between the brake booster push rod and SST.
| Item | Specified Condition |
|---|---|
| for 1GR-FE | -0.21 to 0 (-0.00827 to 0 in.) |
| for 1HZ | -0.1 to 0.11 mm (-0.00394 to 0.00433 in.) |
| for 1VD-FTV |
If there is clearance between SST main body and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.
If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.
Check the push rod clearance again after adjusting.