Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR (w/o VSC) › from 2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0282729 BRAKE ACTUATOR(w/o VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/o VSC)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CONNECT GTS

a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Start the engine and idle it.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

Chassis > ABS/VSC/TRC > Active Test
Tester Display
Motor Relay
50004 105 2
Chassis > ABS/VSC/TRC > Active Test
Tester Display
ABS Solenoid
50004 105 109

Hide 2.CHECK ACTUATOR MOTOR OPERATION

NOTICE:

Do not keep a motor relay on for more than 5 seconds. When operating it consecutively, wait 20 seconds between each operation.


a.

Turn the motor relay on and check the actuator motor operation noise.


b.

Turn the motor relay off.


c.

Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the initial depth of the pedal is maintained for the entire 15 seconds.


d.

Turn the motor relay on and check that the pedal does not pulsate.


e.

Turn the motor relay off and release the pedal.


Hide 3.CHECK RIGHT FRONT WHEEL OPERATION

NOTICE:
·

Be sure to follow the procedures below when turning on a solenoid.

·

Do not keep a solenoid on for more than 5 seconds. When operating it consecutively, wait 20 seconds between each operation.

·

The pedal must not be depressed if only the reduction solenoid SFRR, SFLR or SRRR is turned on.



a.

With the pedal depressed as much as possible, perform the following operations.


b.

Turn the SFRH and SFRR solenoids on simultaneously, and check that the pedal cannot be depressed further.


c.

Turn the SFRH and SFRR solenoids off simultaneously, and check that the pedal can be depressed further.


d.

Turn the motor relay on. Check that the pedal returns to the "depressed as much as possible" position.


e.

Turn the motor relay off and release the pedal.


Hide 4.CHECK OTHER WHEEL OPERATION

a.

Using the same procedure, check the solenoids of the other wheels.

HINT:

Left front wheel: SFLH, SFLR

Rear wheel: SRRH, SRRR