Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR (w/ VSC) › 2016.08–2017.01
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0282734 STEERING ANGLE SENSOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR(w/ VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 7.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

·

When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.



a.
C362243C01
0.729,2.573 0.729,1.677 0.729,1.677 0.49,1.677 true 0.271,1.583 0.583,1.781 0.313,0.198 10 false *a
*a Slider


Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.


b.

Disconnect each connector from the spiral with sensor cable sub-assembly.


c.
C362244

Detach the 3 claws and remove the spiral with sensor cable sub-assembly.