Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH (w/ VSC) › from 2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0282735 VSC OFF SWITCH(w/ VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH(w/ VSC)  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH

a.
C363807C04
0.083,0.083 0.396,0.281 0.313,0.198 10 false *a
*a Component without harness connected
(VSC OFF Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 - 4 Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch.


Hide 84988M 2.INSPECT VSC OFF SWITCH BULB

a.

Apply battery voltage to the connector and check the illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → L49-1
Battery negative (-) → L49-2
Illuminates


If the result is not as specified, replace the VSC OFF switch bulb.