Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47319F 3.REMOVE REAR FLEXIBLE HOSE LH
Remove the union bolt and gasket.
Disconnect the rear flexible hose LH from the rear disc brake cylinder assembly LH.
Disconnect the brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the clip.
4.REMOVE REAR FLEXIBLE HOSE (w/ VSC)
Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.
Remove the 2 clips.
Remove the rear flexible hose.
Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.
Remove the 2 clips.
Remove the rear flexible hose.
47319F 5.REMOVE REAR FLEXIBLE HOSE (w/o ABS, VSC)
Disconnect the brake tube and 3-way from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.
Remove the clip and flexible hose.
6.REMOVE NO. 5 FLEXIBLE HOSE BRACKET (w/ VSC)
Remove the bolt and No. 5 flexible hose bracket from the frame.
7.REMOVE NO. 5 FLEXIBLE HOSE BRACKET (w/o ABS, VSC)
Remove the bolt and No. 5 flexible hose bracket from the frame.
| *A | except Short Body | *B | for Short Body |