Home › Brake › BRAKE (FRONT) › FRONT BRAKE › from 2016.08
RM25T0E _54 Brake _029917 BRAKE (FRONT) _0138480 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47750 2.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

a.

Install the disc brake cylinder assembly LH with the 2 bolts.

Torque:
158 N*m (1611 kgf*cm, 117 ft.*lbf)


Hide 47313A 3.CONNECT FRONT FLEXIBLE HOSE LH

a.

Install the front flexible hose LH and a new gasket to the disc brake cylinder assembly LH with a new union bolt.

Torque:
30.4 N*m (310 kgf*cm, 22 ft.*lbf)

HINT:

Install the flexible hose lock securely in the lock hole in the disc brake cylinder assembly LH.



Hide 04945 4.INSTALL FRONT ANTI-SQUEAL SHIM KIT

C310921C01
0.354,0.573 0.354,0.25 0.354,0.25 0.677,0.25 false 0.865,1.51 0.865,1.958 false 2.479,1.865 2.479,1 2.479,1 2.75,1 false 3.115,2.802 3.115,3.146 3.115,3.146 2.844,3.146 false 0.813,2 1.125,2.156 0.313,0.156 10 false *1 0.729,0.177 1.042,0.333 0.313,0.156 10 false *2 2.667,3.083 2.979,3.24 0.313,0.156 10 false *2 2.792,0.938 3.104,1.094 0.313,0.156 10 false *1
*1 No. 1 Anti-squeal Shim
*2 No. 2 Anti-squeal Shim
V100135

Disc brake grease


a.

Apply disc brake grease to both sides of each No. 1 anti-squeal shim.


b.

Install the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims to each front disc brake pad.

NOTICE:
·

When replacing worn pads, the shims must be replaced together with the pads.

·

Install the shims in the correct position and direction.




Hide 04465 5.INSTALL FRONT DISC BRAKE PAD

a.

Install the 2 front disc brake pads to the disc brake cylinder assembly LH.

NOTICE:

There should be no oil or grease on the friction surface of the pads and disc.



Hide 6.INSTALL FRONT DISC BRAKE ANTI-RATTLE SPRING

a.

Install the front disc brake anti-rattle spring.


b.

Hold down the front disc brake anti-rattle spring and insert the 2 disc brake pad guide pins.


c.

Install the pin hold clip.


Hide 8.BLEED CLUTCH LINE

Hide 9.INSTALL FRONT WHEEL