Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
After replacing the disc brake pads, the clearance between the disc brake pads and front discs becomes larger and the brake pedal feel becomes softer. Therefore, after replacing the disc brake pads, depress the brake pedal several times and check the clearance and brake pedal feel.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
04465 3.REMOVE FRONT DISC BRAKE PAD
| *1 | Disc Brake Pad Guide Pin |
| *2 | Pin Hold Clip |
| *3 | Front Disc Brake Anti-rattle Spring |
Remove the pin hold clip.
Hold down the front disc brake anti-rattle spring and remove the 2 disc brake pad guide pins.
Remove the front disc brake anti-rattle spring.
Do not remove the 2 disc brake pad guide pins without holding down the front disc brake anti-rattle spring. The front disc brake anti-rattle spring will eject with a force capable of causing injury.
Remove the 2 front disc brake pads from the disc brake cylinder assembly LH.
04945 4.REMOVE FRONT ANTI-SQUEAL SHIM KIT
Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each front disc brake pad.
04945 5.INSTALL FRONT ANTI-SQUEAL SHIM KIT
| *1 | No. 1 Anti-squeal Shim |
| *2 | No. 2 Anti-squeal Shim |
|
Disc Brake Grease |
Apply disc brake grease to both sides of each No. 1 anti-squeal shim.
Install the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims to each front disc brake pad.
When replacing worn pads, the shims must be replaced together with the pads.
Install the shims in the correct position and direction.
04465 6.INSTALL FRONT DISC BRAKE PAD
Using SST, push back the front disc brake piston.
Do not forcibly install the piston into the front disc brake cylinder.
Install the 2 front disc brake pads to the disc brake cylinder assembly LH.
There should be no oil or grease on the friction surface of the pads and disc.
Install the front disc brake anti-rattle spring.
Hold down the front disc brake anti-rattle spring and insert the 2 disc brake pad guide pins.
Install the pin hold clip.
Depress the brake pedal several times.
7.ADD BRAKE FLUID
w/ VSC:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/ VSC)>ON-VEHICLE INSPECTION
w/o VSC:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/o VSC)>ON-VEHICLE INSPECTION
w/o ABS:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/o ABS)>ON-VEHICLE INSPECTION
8.INSTALL FRONT WHEEL