Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
48306 1.INSTALL REAR SPRING BUMPER SUB-ASSEMBLY
Install the bumper with the 2 bolts.
48210Q 2.INSTALL REAR SPRING SHACKLE BUSH
Install the 4 bushes to the spring and chassis frame.
48220 3.TEMPORARILY INSTALL REAR SPRING ASSEMBLY LH
Temporarily install the spring to the rear side with the shackle pin, shackle plate, 2 washers and 2 nuts.
Temporarily install the spring to the front side with the hanger pin, washer and nut.
48475R 4.INSTALL REAR DISTANCE PLATE (w/ Distance Plate)
Install the distance plate.
48046A 5.TEMPORARILY INSTALL REAR SPRING U BOLT
Temporarily install the U bolt seat and 2 U bolts with the 4 washers and 4 new nuts.
Install the U bolts so that the lengths of the 4 ends under the U bolt seat are the same.
48540 6.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
Temporarily install the lower mounting bolt, rear No. 1 shock absorber cushion washer and 2 bushing and rear shock absorber assembly LH to the spring U bolt seat sub-assembly LH.
7.INSTALL REAR WHEEL
8.STABILIZE SUSPENSION
Remove the safety stands.
Lower the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
48220 9.TIGHTEN REAR SPRING ASSEMBLY LH
Tighten the 3 nuts.
Install the lock bolt.
48046A 10.TIGHTEN REAR SPRING U BOLT
Tighten the 4 nuts.
Install the U bolts so that the lengths of the 4 ends under the U-bolt seat are the same.
48540 11.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
Tighten the bolt.