If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
This is not a malfunction if the system and sensor circuits are normal and normal VSC operation resumes.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1440 | Steering Angle Sensor Unusual Bank Angle Detected | Driving at a steep bank angle | Yaw rate and acceleration sensor (Airbag sensor assembly) |
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is recorded.
| Proceed to |
|---|
| DTC C1440 is output |
| DTC C1440 is not output |
| Yaw rate and acceleration sensor DTC is output |
DTC C1440 is output
DTC C1440 is not output
Yaw rate and acceleration sensor DTC is output
If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
| Proceed to |
|---|
| NEXT |
NEXT