Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.08
RM25T0E _51 Engine / Hybrid System _057930 CRUISE CONTROL _0287962 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Malfunction  


DESCRIPTION

The speed sensor installed on the wheels outputs wheel speed pulse signals which are then converted to vehicle speed pulse signals by the skid control ECU (brake actuator assembly). These pulse signals are then output to the combination meter assembly as vehicle speed signals and then input to the ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0500 Vehicle Speed Sensor Malfunction The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation ECD system

CAUTION / NOTICE / HINT

This DTC may be output by the ECD system at the same time. In that case, perform troubleshooting for the ECD system first.

PROCEDURE

1.CHECK FOR DTCs
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 237

e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.



f.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 237

Result:
Result Proceed to
DTC P0500 is not output A
DTC P0500 is output B



A

B