84632 1.INSPECT CRUISE CONTROL MAIN SWITCH
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Cruise Control Main Switch) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (ECC) - 3 (CCS) | Cruise control main switch (ON-OFF button) released | 1 MΩ or higher |
| Cruise control main switch (ON-OFF button) pushed | Below 2.5 Ω | |
| +RES switch ON | 236 to 244 Ω | |
| -SET switch ON | 618 to 642 Ω | |
| CANCEL switch ON | 1510 to 1570 Ω |
If the result is not as specified, replace the cruise control main switch.
84633 2.INSPECT CRUISE CONTROL SWITCH WIRE
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Connector C | - | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-3 - B-3 | Always | Below 1 Ω |
| A-4 - B-1 | Always | Below 1 Ω |
| A-2 - C-1 | Always | Below 1 Ω |
If the result is not as specified, replace the cruise control switch wire.