Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for 90 L Tank Carried in Middle) › from 2016.08
RM25T0E _51 Engine / Hybrid System _029892 1GR-FE FUEL _0135869 FUEL SENDER GAUGE ASSEMBLY(for 90 L Tank Carried in Middle) G

1GR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY(for 90 L Tank Carried in Middle)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A386820C03
0.979,1.333 1.219,1.333 1.219,1.333 1.552,1.01 true 1.823,0.635 2.115,0.25 2.115,0.25 2.313,0.25 true 1.865,1.76 2.094,1.958 0.229,0.198 10 false *b 0.74,1.24 1,1.438 0.26,0.198 10 false FE 2.375,0.167 2.635,0.365 0.26,0.198 10 false FV 0.063,0.042 0.302,0.26 0.24,0.219 10 false *a
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals


Apply 5 V between terminals 1 (FV) and 3 (FE).

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 3 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.



ii.
A386814C03
0.458,2.156 0.938,2.156 true 1.333,4.406 1.813,4.406 true 0.323,0.927 0.802,0.927 true 1,1.229 1,1.625 true 0.313,2.073 0.469,2.271 0.156,0.198 10 false F 1.188,4.323 1.344,4.521 0.156,0.198 10 false E 0.073,0.844 0.313,1.042 0.24,0.198 10 false FR 0.927,1.656 1.167,1.854 0.24,0.198 10 false FE 0.052,0.031 0.313,0.229 0.26,0.198 10 false *a
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (FR) - 3 (FE) Float position is F (upper) 4.25 to 4.61 V*
Float position is E (lower) 0.34 to 0.70 V*


*: The output voltage changes depending on the voltage applied to the terminals.


HINT:
·

Output voltage(F) = (0.850 x Voltage applied to terminals) to (0.922 x Voltage applied to terminals)

·

Output voltage(E) = (0.068 x Voltage applied to terminals) to (0.140 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.