Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DPF SWITCH (for DPF) › 2016.08–2021.07
RM25T0E _51 Engine / Hybrid System _029525 1VD-FTV EMISSION CONTROL _0290818 DPF SWITCH(for DPF) G

1VD-FTV EMISSION CONTROL  DPF SWITCH(for DPF)  INSPECTION  


PROCEDURE

Hide 84270K 1.INSPECT DPF SWITCH ASSEMBLY

a.
A391358C01
2.135,1.281 2.615,0.531 2.615,0.531 2.75,0.531 true 1.052,0.604 1.177,0.604 1.177,0.604 1.615,1.281 true 1.969,1.292 2.26,0.292 2.26,0.292 2.396,0.292 true 1.375,0.365 1.5,0.365 1.5,0.365 1.802,1.281 true 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 2.833,0.458 3.24,0.656 0.406,0.198 10 false ILL+ 2.448,0.219 2.854,0.417 0.406,0.198 10 false ILL- 1.24,0.292 1.49,0.49 0.25,0.198 10 false B 0.896,0.542 1.115,0.75 0.219,0.208 10 false E
*a Component without harness connected
(DPF Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (B) - 4 (E) Not Pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the DPF switch assembly.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the DPF switch assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (ILL+)
Battery negative (-) → 2 (ILL-)
Illuminates


If the result is not as specified, replace the DPF switch assembly.