When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
23710B 3.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
Disconnect the exhaust fuel addition injector connector.
| *1 | Washer |
| *2 | Nozzle Holder Clamp |
Remove the bolt, washer and nozzle holder clamp.
Remove the exhaust fuel addition injector and gasket.
23901H 4.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Turn the retainer shown in the illustration.
Check for foreign matter on the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.
Do not use any tools to separate the fuel tube connector and fuel pipe.
Do not forcefully bend, kink or twist the nylon tube.
Keep the fuel tube connector and fuel pipe free from foreign matter.
Put the fuel tube connector and fuel pipe in plastic bags to prevent damage and contamination.
| *1 | Exhaust Fuel Addition Injector |
| *a | Fuel Tube Connector |
| *b | Retainer |
| *c | O-Ring |
Disconnect the fuel tube connector from the exhaust fuel addition injector.
23255B 5.REMOVE FUEL INJECTOR SEAL
| *1 | Fuel Injector Seal |
Remove the fuel injector seal from the exhaust fuel addition injector assembly.