Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR(for DPF) › from 2016.08
RM25T0E _51 Engine / Hybrid System _029525 1VD-FTV EMISSION CONTROL _0290817 DIFFERENTIAL PRESSURE SENSOR(for DPF) A

1VD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR(for DPF)  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Connect the No. 1 air hose and No. 2 air hose to the differential pressure sensor, and slide the 2 clamps to secure the hoses.


b.

Install the differential pressure sensor with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.
A391364C01
1.677,2.5 1.677,1.698 1.677,1.698 2.188,1.698 true 1.969,2.927 2.313,3.219 2.313,3.219 2.448,3.219 true 1.083,3.188 1.198,3.188 1.198,3.188 1.646,2.938 true 1.958,2.479 1.958,1.708 true 2.26,1.615 2.458,1.792 0.198,0.177 10 true *a 0.875,3.094 1.052,3.26 0.177,0.167 10 true *b 2.51,3.135 2.708,3.313 0.198,0.177 10 true *c 0.406,1.115 0.719,1.271 0.313,0.156 10 false *d 1.167,1.125 1.479,1.281 0.313,0.156 10 false *e 2.844,1.146 3.156,1.302 0.313,0.156 10 false *e 2.083,1.146 2.396,1.302 0.313,0.156 10 false *d 1.781,0.5 1.938,0.698 0.156,0.198 10 false A 2.5,0.229 2.656,0.427 0.156,0.198 10 false B
*a Marking
*b Red Paint Mark
*c Purple Paint Mark
*d CORRECT
*e INCORRECT


Install the No. 1 air hose and No. 2 air hose to the differential pressure sensor with 2 new clips.

NOTICE:
·

Connect the air hoses so that the paint marks of the air hoses are as shown in the illustration.

·

Make sure the end of the clip is 14.3 mm (0.563 in.) or less from the end of the exhaust pipe air hose when installing the clip as shown by A in the illustration.

·

Make sure the clip does not protrude beyond the end of the hose as shown by B in the illustration.




d.

Connect the differential pressure sensor connector.