Home › General › SPECIFICATIONS › 1VD-FTV ENGINE CONTROL › 2016.08–2019.09
RM25T0E _V1 General _029810 SPECIFICATIONS _0145748 1VD-FTV ENGINE CONTROL F

SPECIFICATIONS  1VD-FTV ENGINE CONTROL  SERVICE DATA  


DIESEL THROTTLE BODY
Tester Connection Condition Specified Condition
1 (DUTY) - Body ground Always 10 kΩ or higher
2 (+B) - Body ground Always 10 kΩ or higher
3 (GND) - Body ground Always 10 kΩ or higher
2 (+B) - 1 (DUTY) Always 10 kΩ or higher
1 (DUTY) - 3 (GND) Always 10 kΩ or higher

ACCELERATOR PEDAL
Tester display Condition Specified Condition
Accelerator position No. 1 Released 10 to 22%
Depressed 52 to 90%
Accelerator position No. 2 Released 24 to 40%
Depressed 68 to 99%

MASS AIR FLOW METER (w/o DPF)
Tester Connection Condition Specified Condition
4 (THA) - 5 (E2) Always 0.48 to 17.7 kΩ

CAMSHAFT POSITION SENSOR
Tester Connection Condition Specified Condition
1 - 2 Cold 835 to 1400 Ω
1 - 2 Hot 1060 to 1645 Ω

CRANKSHAFT POSITION SENSOR
Tester Connection Condition Specified Condition
1 (NE+) - 2 (NE-) Cold 1630 to 2740 Ω
1 (NE+) - 2 (NE-) Hot 2065 to 3225 Ω

ENGINE COOLANT TEMPERATURE SENSOR (w/ DPF)
Tester Connection Condition Specified Condition
1 - 2 approximately 20°C (68°F) 2.32 to 2.59 kΩ
1 - 2 approximately 80°C (176°F) 0.31 to 0.326 kΩ

ENGINE COOLANT TEMPERATURE SENSOR (w/o DPF)
Tester Connection Condition Specified Condition
1 - 2 approximately 20°C (68°F) 2.29 to 2.60 kΩ
1 - 2 approximately 80°C (176°F) 0.302 to 0.327 kΩ

INTAKE AIR TEMPERATURE SENSOR
Tester Connection Condition Specified Condition
1 - 2 approximately 20°C (68°F) 2.21 to 2.65 kΩ
1 - 2 approximately 60°C (140°F) 0.55 to 0.61 kΩ

MANIFOLD ABSOLUTE PRESSURE SENSOR
Tester Connection Condition Specified Condition
T25-3 (VC) - T25-1 (E2) Ignition switch ON 4.75 to 5.25 V

AIR FUEL RATIO SENSOR (for DPF)
Tester Connection Condition Specified Condition
1 (HAF) - 2 (+B) 20°C (68°F) 1.8 to 3.4 Ω
1 (HAF) - 4 (AF1-) Always 10 kΩ or higher

POWER STEERING OIL PRESSURE SWITCH
Condition Specified Condition
Power steering operation ON
Power steering not operation OFF

RELAY (EFI MAIN RELAY)
Tester Connection Condition Specified Condition
3 - 5 battery voltage is not applied between 1 and 2 10 kΩ or higher
3 - 5 battery voltage is applied between 1 and 2 Below 1 Ω

RELAY (EDU1, EDU2)
Tester Connection Condition Specified Condition
3 - 5 battery voltage is not applied between 1 and 2 10 kΩ or higher
3 - 5 battery voltage is applied between 1 and 2 Below 1 Ω

RELAY (A/F RELAY)
Tester Connection Condition Specified Condition
3 - 5 battery voltage is not applied between 1 and 2 10 kΩ or higher
3 - 5 battery voltage is applied between 1 and 2 Below 1 Ω