Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2017.01–2021.07
RM25T0E _53 Suspension _062777 TIRE PRESSURE MONITORING _0306275 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light.

WIRING DIAGRAM

C171960E18
5.156,2.063 6.865,2.5 1.708,0.438 10 false Tire Pressure Warning ECU and Receiver 5.531,0.531 5.656,0.698 0.125,0.167 10 false 3 5.771,0.708 6.063,0.885 0.292,0.177 10 false TC 0.781,1.802 1.104,1.969 0.323,0.167 10 false I17 0.781,1.99 1.302,2.177 0.521,0.188 10 false DLC3 1.188,0.688 1.5,0.885 0.313,0.198 10 false TC 1.146,1.292 1.396,1.51 0.25,0.219 10 false CG 1.49,0.583 1.688,0.76 0.198,0.177 10 false 13 1.521,1.156 1.729,1.333 0.208,0.177 10 false 4 5.146,1.823 6.438,2.052 1.292,0.229 10 false S30*1, Y7*2, U5*3 2.594,1.604 5.344,1.802 2.75,0.198 10 false *1: for Single Cab 2.615,1.917 5.365,2.115 2.75,0.198 10 false *2: for Double Cab 2.625,2.24 4.917,2.5 2.292,0.26 10 false *3: except Single and Double Cabs

CAUTION / NOTICE / HINT

HINT:

When each warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
a.

Turn the ignition switch off.


b.

Disconnect the S30*1, Y7*2 or U5*3 tire pressure warning ECU and receiver connector.

*1: for Single Cab

*2: for Double Cab

*3: except Single and Double Cabs



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I17-13 (TC) - S30-3 (TC)*1
I17-13 (TC) - Y7-3 (TC)*2
I17-13 (TC) - U5-3 (TC)*3
Always Below 1 Ω
I17-13 (TC) or S30-3 (TC) - Body ground*1
I17-13 (TC) or Y7-3 (TC) - Body ground*2
I17-13 (TC) or U5-3 (TC) - Body ground*3
Always 10 kΩ or higher
I17-4 (CG) - Body ground Always Below 1 Ω


*1: for Single Cab

*2: for Double Cab

*3: except Single and Double Cabs



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR