CHECK TIRE PRESSURE WARNING ECU AND RECEIVER
| *A | for Single Cab | *B | for Double Cab |
| *C | except Single and Double Cabs | - | - |
| *a | Front view of wire harness connector (to Tire Pressure Warning ECU and Receiver) |
- | - |
Disconnect the S30*1, Y7*2 or U5*3 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.
*1: for Single Cab
*2: for Double Cab
*3: except Single and Double Cabs
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| S30-1 (IG) - S30-12 (GND)*1 Y7-1 (IG) - Y7-12 (GND)*2 U5-1 (IG) - U5-12 (GND)*3 |
B-Y - W-B | IG power source | Ignition switch ON | 10 to 16 V |
| S30-12 (GND) - Body ground*1 Y7-12 (GND) - Body ground*2 U5-12 (GND) - Body ground*3 |
W-B - Body ground | Ground | Always | Below 1 Ω |
*1: for Single Cab
*2: for Double Cab
*3: except Single and Double Cabs
Connect the S30*1, Y7*2 or U5*3 tire pressure warning ECU and receiver connector.
*1: for Single Cab
*2: for Double Cab
*3: except Single and Double Cabs
Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.
Measure the values on the wire harness side while the connector is connected.
| *A | for Single Cab | *B | for Double Cab |
| *C | except Single and Double Cabs | - | - |
| *a | Component with harness connected (Tire Pressure Warning ECU and Receiver) |
- | - |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| S30-7 (CLSW) - S30-12 (GND)*1 Y7-7 (CLSW) - Y7-12 (GND)*2 U5-7 (CLSW) - U5-12 (GND)*3 |
V - W-B | Tire pressure warning reset switch |
·
Ignition switch ON
·
Tire pressure warning reset switch on |
Below 1.5 V |
|
·
Ignition switch ON
·
Tire pressure warning reset switch off |
8 to 15 V |
*1: for Single Cab
*2: for Double Cab
*3: except Single and Double Cabs