Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM (for RHD with VSC) › from 2017.01
RM25T0E _57 Power Source / Network _057931 NETWORKING _0306319 CAN COMMUNICATION SYSTEM(for RHD with VSC) L

NETWORKING  CAN COMMUNICATION SYSTEM(for RHD with VSC)  PRECAUTION  


STEERING SYSTEM HANDLING PRECAUTIONS


a.

Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.



SRS AIRBAG SYSTEM HANDLING PRECAUTIONS


a.

This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as the driver airbag and front passenger side airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System.



BUS LINE REPAIR


a.
C275044C01
1.708,0.979 1.823,0.385 1.823,0.385 2.271,0.385 false 2.333,0.281 2.646,0.479 0.313,0.198 10 false *a
*a Soldered Area to Be Wrapped with Electrical Tape


After repairing a bus line with solder, wrap the repaired area with electrical tape.

NOTICE:
·

When installing, make sure that these lines are twisted, because CAN bus lines are likely to be influenced by electrical noise if the bus lines are not twisted.

·

Ensure that there is no gap between the CANH wire and CANL wire.

·

Make sure that the distance between the first twist of the wires and the connector is less than 80 mm (3.15 in).

·

When repairing the CAN bus lines, do not change the length of the lines. (Make sure that the length of the CANH bus line and CANL bus line are the same.)




b.
C147144C16
1.971,1.708 2.130,1.849 0.159,0.141 10 *1 1.729,1.47 1.845,1.803 1.845,1.803 1.954,1.803 false
*1 By-pass Wire


Do not use by-pass wiring between the connectors.

NOTICE:

The protective effect of the twisted wire harness will be lost if bypass wiring is used.




CONNECTOR HANDLING


a.
E120443C12
1.802,1.219 1.323,1.604 1.323,1.604 1.542,1.542 true 1.073,1.521 1.281,1.688 0.208,0.167 10 false *1
*1 Tester Probe


When inserting probes into a connector, insert them from the rear of the connector.


b.
E120444C13
1.448,0.917 1.875,0.594 1.875,0.594 1.531,1.302 true 1.875,0.594 1.958,0.594 false 1.979,0.51 2.167,0.677 0.188,0.167 10 false *1
*1 Repair Wire


Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.