Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System) › from 2017.01
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0287798 VEHICLE STABILITY CONTROL SYSTEM(w/o Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/o Pre-collision System)  C1203  ECM Communication Circuit Malfunction  


DESCRIPTION

The circuit is used to send TRC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1203 ECM Communication Circuit Malfunction Any of the following is detected:
1.

Engine model information sent from the ECM does not match the information stored in the skid control ECU.

2.

No system information stored in the skid control ECU.

3.

Incorrect installation of the skid control ECU or ECM.


·

ECM malfunction or ECM with incorrect part number installed

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>CALIBRATION


PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.


Result:
Result Proceed to
Proper ECM is installed A
Proper ECM are not installed B



A

2.CHECK BRAKE ACTUATOR ASSEMBLY

B

2.CHECK BRAKE ACTUATOR ASSEMBLY
a.

Check if the brake actuator assembly had been replaced before the DTC was recorded.


Result:
Proceed to
The brake actuator assembly is not replaced
The brake actuator assembly is replaced



The brake actuator assembly is not replaced

3.RECONFIRM DTC

The brake actuator assembly is replaced

4.PERFORM INITIALIZATION AND CALIBRATION
3.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Check if the same DTC is recorded.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Proceed to
DTC C1203 is not output
DTC C1203 is output



DTC C1203 is not output

DTC C1203 is output

4.PERFORM INITIALIZATION AND CALIBRATION

Result:
Proceed to
NEXT



NEXT

5.RECONFIRM DTC
5.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Check if the same DTC is recorded.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Proceed to
DTC C1203 is not output
DTC C1203 is output



DTC C1203 is not output

END

DTC C1203 is output