Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/ VSC) › from 2017.01
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0282726 BRAKE MASTER CYLINDER(w/ VSC) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/ VSC)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47201 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for LHD)

a.
C375470

Disconnect the clutch reservoir tube from the master cylinder.


b.

Disconnect the brake fluid warning switch connector.


c.

Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.


d.
C375471

Remove the 2 nuts.


e.

Pull out the brake master cylinder sub-assembly from the brake booster assembly.

NOTICE:

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



f.

Remove the O-ring and gasket from the brake master cylinder sub-assembly.


Hide 47201 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for RHD)

a.
C364628

Disconnect the brake fluid warning switch connector.


b.

Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.


c.
C364629

Remove the 2 nuts.


d.

Pull out the brake master cylinder sub-assembly from the brake booster assembly.

NOTICE:

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



e.

Remove the O-ring and gasket from the brake master cylinder sub-assembly.