Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR System) › 2017.01–2017.09
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0309414 ECD SYSTEM(w/o EGR System) D

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR System)  INITIALIZATION  


INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY


HINT:

When the diesel throttle body assembly is replaced, perform initialization.


a.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.



FUEL SUPPLY PUMP INITIALIZATION PROCEDURE


HINT:

After replacing the fuel supply pump assembly and/or the ECM:

·

If the engine is defective or stalls immediately after startup, the ECM's learned values must be initialized. The engine can be initialized through the GTS or by connecting the DLC3 terminals.

·

If the engine starts normally, initialization is not necessary. Perform the step "idle the engine" procedure below only.



a.
A280985

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



c.

Turn the GTS ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Utility / Supply Pump Initialization.

Powertrain > Engine and ECT > Utility
Tester Display
Supply Pump Initialization
50005 61 163

e.

Press "Next".


f.
A280986

Press "Next".


g.
A280987

Press "Exit".


h.

Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning.


i.

Idle the engine for at least 1 minute under the following conditions:

·

The engine coolant temperature is 60°C (140°F) or more.

·

The fuel temperature is 20°C (68°F) or more.


NOTICE:

Do not race the engine immediately after starting the engine. After warming up the engine, racing the engine is acceptable.


HINT:
·

The engine coolant temperature can be estimated by touching the outlet hose.

·

The fuel temperature can be estimated by using the ambient temperature as a substitute.

·

If the engine coolant temperature is difficult to estimate, use the GTS and enter the following menus: Engine and ECT / Data List / Coolant Temp.




j.

Initialization is complete.