Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR System) › 2017.01–2017.09
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0309414 ECD SYSTEM(w/o EGR System) D

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR System)  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display current and pending DTCs.

·

The same DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 61

e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.

Powertrain > Engine and ECT > Clear DTCs
50002 61

e.

Press the YES button.



CLEAR DTC (Without using GTS)


a.

Perform either one of the following operations.

i.

Disconnect the negative battery cable for more than 1 minute.


ii.

Remove the EFI MAIN fuse from the fuse block assembly (located inside the vehicle) for more than 1 minute.