Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73220 1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
| *1 | Bolt A |
| *2 | Bolt B |
Attach the guide and temporarily install the front seat outer belt assembly LH with the bolt (A) and (B).
Tighten the bolt (A).
Tighten the bolt (B).
Check that the front seat outer belt assembly LH is not twisted.
Tighten the bolt and install the shoulder anchor of the front seat outer belt assembly LH.
Check that the front seat outer belt assembly LH is not twisted.
Attach the 2 claws to close the shoulder anchor cover of the front seat outer belt assembly LH.
Install the floor anchor of the front seat outer belt assembly LH with the bolt.
62512 2.INSTALL QUARTER INSIDE TRIM BOARD LH
for 3 Point Type Rear Seat Belt:
Attach the 13 clips and install the quarter inside trim board LH.
except 3 Point Type Rear Seat Belt:
for LH Side:
Attach the 12 clips and install the quarter inside trim board LH.
for RH Side:
Attach the 12 clips and install the quarter inside trim board LH.
73298B 3.INSTALL QUARTER TRIM BELT HOLE COVER LH
Pass the front seat outer belt assembly LH through the gap of the quarter trim belt hole cover LH.
Install the quarter trim belt hole cover LH with the 2 screws.
73299 4.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER LH (for 3 Point Type Rear Seat Belt)
Pass the rear seat outer 3 point type belt assembly LH through the gap of the No. 2 quarter trim belt hole cover LH.
Install the No. 2 quarter trim belt hole cover LH with the 2 screws.